Click on the Title, Author or Picture to open an Entry

Displaying entries 41-48 out of 48.

Application of Solution Mapping to Reduce Computational Time in Actively Cooled Power Electronics

Kirk Lowe, Oak Ridge National Laboratory, and Rao V. Arimilli, University of Tennessee
Last updated: May 1, 2009

4 reviews

In some power electronic applications the available coolant temperature is close to maximum and controlling operating temperature becomes more challenging, for which new thermal management schemes...

Exploratory FEM-Based Multiphysics Oxygen Transport and Cell Viability Models for Isolated Pancreatic Islets

Peter Buchwald, Diabetes Research Institute and the Department of Molecular and Cellular Pharmacology, University of Miami
Last updated: April 30, 2009

7 reviews

Cellular-level oxygen consumption and cell viability models incorporating physiologically realistic assumptions and fully scaled 2D/3D geometries have been implemented in COMSOL Multiphysics for...

A Finite Element Analysis on the Modeling of Heat Release Rate, as Assessed by a Cone Calorimeter, of Char Forming Polycarbonate

D. Statler, Mid-Atlantic Technology, Research and Innovation Center, and R. Gupta, West Virginia University
Last updated: April 30, 2009

Not rated

During the pyrolysis and combustion of polymers, heat is released and is typically measured with a cone calorimeter to better assess the polymer’s flammability. Modeling heat release rate, as...

Study of Compliance Mismatch within a Stented Artery

Kefu Liu and Gianmarc Coppola, Lakehead University
Last updated: April 30, 2009

1 review

The objective of this paper is to study the effects of compliance mismatch in a stented artery. COMSOL Multiphysics is used to tackle this challenging problem involving fluid-structure...

Heat, Air and Moisture Transport - part 2/2 (3D)

A.W.M. (Jos) van Schijndel, Eindhoven University of Technology
Last updated: February 3, 2009

10 reviews

This work presents a first modeling guide for the modeling and simulation of up to full 3D dynamic Heat, Air & Moisture (HAM) transport of building constructions using COMSOL. PART 2/2: HAM...

Heat, Air and Moisture Transport - part 1/2 (2D)

A.W.M. (Jos) van Schijndel, Eindhoven University of Technology
Last updated: February 3, 2009

5 reviews

This work presents a first modeling guide for the modeling and simulation of up to full 3D dynamic Heat, Air & Moisture (HAM) transport of building constructions using COMSOL. PART 1/2 : HAM...

Heat and Moisture Benchmark

A.W.M. (Jos) van Schijndel, Eindhoven University of Technology
Last updated: January 29, 2009

4 reviews

Benchmarks are important tools to verify computational models. In the research area of building physics, the so-called HAMSTAD (Heat, Air and Moisture STAnDardization) project is a very well known...

Middle Cerebral Artery Segment with Vasospasm

Steven Conrad, LSU Health Sciences Center
Last updated: December 19, 2008

6 reviews

This model represents a stenosis due to vasospasm in the M1 segment of the middle cerebral artery, as might occur following subarachnoid hemorrhage. The model is intended to simulate blood flow at...