Galeria de Modelos

A Galeria de Modelos possui arquivos do COMSOL Multiphysics de várias áreas de aplicação incluindo elétrica, mecânica, escoamento e química. Você pode baixar modelos prontos e também tutoriais passo-a-passo para montar seu modelo, e usá-lo como ponto de partida para o seu próprio modelo. Use a função de busca "Quick Search" para encontrar modelos na sua área de interesse e faça o login ou o seu cadastro no COMSOL Access, cadastrando a sua licença do COMSOL, para poder baixar os arquivos.

Capacitive Pressure Sensor

A capacitive pressure sensor is simulated. This model shows how to simulate the response of the pressure sensor to an applied pressure, and also how to analyze the effects of packing induced stresses on the sensor performance.

Three-Cylinder Reciprocating Engine

In this example, a dynamic analysis of a three-cylinder reciprocating engine is performed to investigate stresses generated during operation, thereby permitting identification of the critical components. Demand for high power output relative to the weight of the engine requires careful design of its components. This model of a reciprocating engine contains a combination of rigid and flexible ...

Computing Capacitance in a Comb Drive

Capacitive comb drives are commonly used both as actuators and position sensors. The following model focuses on position measurement. Many approaches exist for positional measurements with MEMS devices, of which capacitance measurement is the most widely used, particularly in micro-accelerometers. In a pair of interdigitated combs the fingers of one comb do not touch those of the other comb, ...

Packed Bed Reactor

One of the most common reactors in the chemical industry, for use in heterogeneous catalytic processes, is the packed bed reactor. This type of reactor is used both in synthesis as well as in effluent treatment and catalytic combustion. The reactor consists in essence of a container filled with catalyst particles. These particles can be contained within a supporting structure, like tubes or ...

1D Isothermal Lithium-Ion Battery

This model demonstrates the Lithium-Ion Battery interface for studying the discharge and charge of a lithium-ion battery for a given set of material properties. The geometry is in one dimension and the model is isothermal. Battery developers can use the model to investigate the influence of various design parameters such as the choice of materials, dimensions, and the particle size distribution ...

Forced and Natural Convection Cooling of Circuit Boards

The suite of models examine the air cooling of circuit boards populated with multiple integrated circuits (ICs), which act as heat sources. Two possible cooling scenarios are depicted: vertically aligned boards using natural convection, and horizontal boards with forced convection (fan cooling). In this case, contributions caused by the induced (forced) flow of air dominate the cooling. To ...

Frequency Selective Surface, Periodic Complementary Split Ring Resonators

Frequency selective surfaces (FSS) are periodic structures with a bandpass or a bandstop frequency response. This model shows that only signals around the center frequency can pass through the periodic complimentary split ring resonator layer.

Optical Scattering off of a Gold Nanosphere

This model demonstrates the calculation of the scattering of a plane wave of light off of a gold nanosphere. The scattering is computed for the optical frequency range, over which gold can be modeled as a material with negative complex-valued permittivity. The far-field pattern and the losses are computed.

Two-Phase Flow in Porous Media

The first model describes the simultaneous flow of two immiscible fluids in porous media - here air displaces water in a multi-step inlet pressure experiment. We solve for the pressure and the degree saturation for the air and water within a representative volume and so track saturation levels rather than estimating a discrete location for the air-water interface. A second example is also ...

Piezoelectric Shear-Actuated Beam

The model performs a static analysis on a piezoelectric actuator based on the movement of a cantilever beam, using the Piezoelectric Devices predefined multiphysics interface. Inspired by work done by V. Piefort and A. Benjeddou, it models a sandwich beam using the shear mode of the piezoelectric material to deflect the tip.

Quick Search