ABB, Corporate Research, Västerås, Sweden
Modern power transmission systems are in general designed to operate at high voltages in order to reduce resistive losses generated by high currents. This, however, tends to increase the risk for dielectric breakdown or flashovers if the equipment is not properly designed to withstand the stress. The present work illustrates how multiphysics simulations can be used to analyze and predict the ...
U. N. Mughal, M. S. Virk
Narvik University College, Narvik, Norway
Atmospheric ice is a very complex material with varying electrical properties due to different polymorphs of ice itself. Also, if the medium to be considered is snow, then density becomes an additional parameter because it is a mixture of three dielectrics water, ice and air. The permittivity and loss tangent of naturally occurring ice and snow shows lot of variation at different conditions ...
S. Lefeuvre, M. Ghomi
EURL CREAWAVE, Labège, France
CALCEM, Ste Foy d'Aigrefeuille, France
COMSOL, adding SPICE® elements into its FEM, gives the possibility of a direct modeling of oscillators: triode and load are FEM described while all the other components of the circuit are just simulated using SPICE®. The modeling is not a straight application of any module but needs the previous computation of the conductivity of the beam through the PDE interface. This paper is a bench mark ...
N.S. Lawand, J. van Driel, P.J. French
Electronic Instrumentation Laboratory (EILab), Faculty of Electrical Engineering, Mathematics and Computer Science (EEMCS), Delft University of Technology, Delft, The Netherlands
Delft University of Technology, Delft, The Netherlands
Cochlear Implants are implantable devices which bypasses the non-functional inner ear and directly stimulates the hearing nerve with electric currents thus enabling deaf people to experience sound again. Implant electrode array design is limited in electrode count, due to their large size in accordance to scala tympani (ST) with restrictions for deeper insertion in ST thus depriving access to low ...
N. Badi, R. Mekala
Department of Physics, Center for Advanced Materials, University of Houston, Houston, TX, USA
Department of Electrical & Computer Engineering, University of Houston, Houston, TX, USA
Thermally conducting but electrically insulating materials are needed for heat-sink LED lighting applications. We report on a cost effective and innovative method based on creating core-shell nanoparticles in polymer with aluminum (Al) nanoparticles as the high thermal conductivity core and ultrathin aluminum oxide (Al?O?) as a capping shell. The solid oxide shell around the Al core prevents ...
School for Engineering of Matter, Transport, and Energy, Arizona State University, Tempe, AZ, USA
Chemistry Department, United States Naval Academy, Annapolis, MD, USA
Flexible electronics are temporarily affixed to a rigid carrier such as glass or silicon prior to device fabrication to facilitate robotic handling of the device, but also to allow optical lithography to stay within overlay design registration budget; without the rigid carrier, a freestanding flexible substrate such as polyimide would distort unacceptably during even minor temperature excursions ...
D.A. Sanz Becerra, E.A. Unigarro Calpa, J. Osma, F. Segura
Universidad de los Andes, Bogotá, Colombia
A scheme for inductive wireless powering and readout of passive LC sensor is presented. The sensor’s inductor is designed as a planar square coil and is used as the power receiving component. The capacitor is connected directly to the inductor and it was designed as an interdigital capacitor. With a transmitting coil (coupling antenna), an electromagnetic field is generated which couples with ...
S.M. Dutta, A. Reiderman
Baker Hughes, Houston, TX, USA
Waterflooding and steam-flooding are used worldwide for EOR. Recently, CO2-flooding has attracted global attention as a means of EOR as well as for carbon capture and sequestration. These processes cause significant changes over time in the fluid composition of oil reservoirs. This paper demonstrates the feasibility of a borehole transient electromagnetic (TEM) system that can map the fluid ...
I.M. Abdel-Motaleb, K. Allen 
Department of Electrical Engineering, Northern Illinois University, DeKalb, IL, USA
The design of a RFID-enabled temperature sensor is described in this paper. In this sensor, a change in temperature causes structural beams to bend, which results in a proportional displacement of the plates of the capacitor. Plates\' displacement results, in turn, in changing the value of its capacitance. The capacitor of the sensor is coupled to the LC resonant network of a passive RFID tag. ...
Y.A. Urzhumov[,], N.I. Landy[,], C. Ciraci, D.R. Smith[,]
Department of Electrical and Computer Engineering, Pratt School of Engineering, Duke University, Durham, NC, USA
Center for Metamaterials and Integrated Plasmonics, Pratt School of Engineering, Duke University, Durham, NC, USA
Linear wave propagation through inhomogeneous structures of size R?? (Fig.1) is a computationally challenging problem, in particular when using finite element methods, due to the steep increase of the number of degrees of freedom as a function of R/?. Fortunately, when the geometry of the problem possesses symmetries, one may choose an appropriate basis in which the stiffness matrix of the ...